If at all possible do your mixing and testing under a repeatable consistent light source such as a Daylight LED which should have an RGB balance of 255-255-255 or pure white.ĭisclaimer: This is the experience of a guy who fixes elevators. If you are not happy with the color match, you can add more pigment until you achieve a closer match. Start comparing the RGB content to a section of the boat which is similarly dulled down.Ĥ. When set, pop off the sample and dull it down with 1500 (or so) sandpaper.ģ. Yellow, brown and black should cover any of the typical boat interior colors. Its a time consuming process even for a pro to match by eye. Keep dabbing it onto the original surface to get a comparison. When you get close to a match add a drop of hardener to a bit of your mix and do a test on a piece of clean, waxed glass. Start with a very small amount of yellow tint mixed in white gel coat. The app reads wet gel coat much different than dry.Ģ. At this point I was still too white and slowly added more grey until I got a match.ġ. of the grey colorant to 100 ml of white gelcoat base.ĥ. of white gelcoat base with 2 small drops of black colorant in a small enclosed container. Keep checking your boat color with the app each time you adjust your mix, it will shift with light and shadows.ģ. Based on the "Swatches" phone app the RGB (Red-Green-Blue) content of my boat is very close to equal on all three.Ģ. My experience on a 1994 200 Osprey is as follows:ġ. Also I'm no expert so take it for what it's worth. We are the 1 source for aftermarket Gel-Coat and the only Gel-Coat refinishing manufacturer in.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |